mirror of
https://github.com/karl0ss/AnotterKiosk.git
synced 2025-10-27 20:54:22 +00:00
64 lines
1.3 KiB
Plaintext
Executable File
64 lines
1.3 KiB
Plaintext
Executable File
#hdmi_safe=1
|
|
|
|
#overscan_left=16
|
|
#overscan_right=16
|
|
#overscan_top=16
|
|
#overscan_bottom=16
|
|
|
|
# uncomment to force a console size. By default it will be display's size minus
|
|
# overscan.
|
|
framebuffer_width=1920
|
|
framebuffer_height=1080
|
|
|
|
# uncomment if hdmi display is not detected and composite is being output
|
|
hdmi_force_hotplug=1
|
|
|
|
# uncomment to force a specific HDMI mode (this will force VGA)
|
|
#hdmi_group=1
|
|
#hdmi_mode=1
|
|
|
|
# uncomment to force a HDMI mode rather than DVI. This can make audio work in
|
|
# DMT (computer monitor) modes
|
|
#hdmi_drive=2
|
|
|
|
# uncomment to increase signal to HDMI, if you have interference, blanking, or
|
|
# no display
|
|
#config_hdmi_boost=4
|
|
|
|
enable_uart=1
|
|
disable_splash=1
|
|
dtparam=audio=on
|
|
gpu_mem=256
|
|
#dtparam=spi=on
|
|
|
|
# Enable DRM VC4 V3D driver
|
|
#dtoverlay=vc4-kms-v3d
|
|
#max_framebuffers=2
|
|
|
|
# Rotate the screen
|
|
display_hdmi_rotate=1
|
|
|
|
# Run in 64-bit mode
|
|
arm_64bit=1
|
|
|
|
# Disable compensation for displays with overscan
|
|
disable_overscan=1
|
|
|
|
[cm4]
|
|
# Enable host mode on the 2711 built-in XHCI USB controller.
|
|
# This line should be removed if the legacy DWC2 controller is required
|
|
# (e.g. for USB device mode) or if USB support is not required.
|
|
otg_mode=1
|
|
|
|
[pi3]
|
|
arm_freq=1350
|
|
core_freq=500
|
|
gpu_freq=500
|
|
over_voltage=4
|
|
|
|
[pi4]
|
|
# Run as fast as firmware / board allows
|
|
arm_boost=1
|
|
|
|
[all]
|
|
avoid_warnings=1 |